I have created the first three of our scheduled jobs, they have a linear 1 -> 2 -> 3 dependency. Following the help file instructions, I dragged job one over to the right side of the Dependency Editor, then job 2. I then right clicked job one on the right side, and dragged to job 2 to form the dependency. Now I repeat for job 3 and the job 2 -> 3 dependency. When I "apply" and "save", job 2 goes to disabled state. When I look at the job properties, job 1 has two semaphore file dependencies (it should have none), and job 2 has none (it should have 1). I have tried this a few different ways, do jobs 1 & 2 first then exit the editor, save, come back and add job 3. Always the same result.

Thanks, Joe

The job 2 is disabled because one or more mandatory properties left blank. See job log for details. It should exact explanation why job 2 was disabled.

: I have created the first three of our scheduled jobs, they have a linear 1
: -> 2 -> 3 dependency. Following the help file instructions, I
: dragged job one over to the right side of the Dependency Editor, then job
: 2. I then right clicked job one on the right side, and dragged to job 2 to
: form the dependency. Now I repeat for job 3 and the job 2 -> 3
: dependency. When I "apply" and "save", job 2 goes to
: disabled state. When I look at the job properties, job 1 has two semaphore
: file dependencies (it should have none), and job 2 has none (it should
: have 1). I have tried this a few different ways, do jobs 1 & 2 first
: then exit the editor, save, come back and add job 3. Always the same
: result.

: Thanks, Joe