Are there any command line parameters that you pass to 24x7.exe? Make sure you don't have "/NOTIMER" there. All changes made on the Master should get to the Standby, including new folders and jobs no matter how they were created. But, initial job database file must be the same (v1.6 comming soon, will allow multiple job databases and the Standby will not require any database to be loaded on start up). : I copied the Schedule.dat to the Standby computer, launched 24x7 and waited a : minute for the status bar message, "3 jobs replicated", closed : the master, at the next replication interval the Standby took over and : launched but the time said the were no jobs scheduled to run, to get it to : work i had to make a change in one of the active jobs and press save, then : the correct job was displayed and the timer was fine. How do i get it to : automatically turn the timer on and take over, and if any changes are made : in the master while the standby is on should those changes be seen on the : standby, ie a new folder with a job in it?
|